Suzuki RF600R
(94-96)

Factory Pro Series "S19"

The middleweight RF600 was one of the smoothest 600's around  - like a highly refined Katana. Delivering better top-end power with the same generous serving of low-end and midrange.
The Carb Recal Kit and the Ignition Advance Rotor perks up the low-end and midrange power and response for quicker warm-up and more response. The Transmission Detent Spring Kit really puts "snap" into the shifting and virtually eliminates missed shifts in a good transmission.


 

Factory Pro Carb Recalibration Kits / jet kits

Long Boy Extended Fuel Screw set
pn: CRZ-SCR-SUZ-5020M
$89.95
 with 4 new screws, springs, washers and o-rings

1. Choose your shipping method

2.

 

"Long Boy"

Finger adj. extended Fuel Screw Kit

Frustrated with trying to find an "almost 90 degree"  screwdriver to fine adjust your fuel screws for best idle and cruise?
Use Factory Pro's new "finger adjustable" fuel screws to adjust fuel screws for best throttle response. Traveling to high altitude? It's easy to lean out the lowend temporarily.

Make your life easier.

Installation:
Remove old short stock fuel screws, old orings, old washers and old spring. The o-ring might be stuck in the carb, so, take a light and make sure it's really out if it didn't come out with the screw (or you can't find it after you took out the screw)
Use a small bent wire to pull it out if it doesn't drop out. Keep the old parts for "spares".

Fuel screw assembly comes with:
4 Long Boy fuel screws
 4 new o-rings
4 new washers
4 new springs


CRB-S19-1.0
Standard drop-in carb kit
$139.95

International buyers will be billed additional $18 for shipping

The kit, when properly tuned, adds more low-end / midrange and if the proper main jet is selected, more top-end power. Easy to install and tune - no slide drilling! 


CRB-S19-1.1-ti
$159.95


International buyers will be billed additional $18 for shipping

Ti ProKit carb kit
 

Titanium needles. The toughest material used in a carburetor. These needles will still be around in the millennium after next. Ti, in this application are unbeatable for long life.

The kit, when properly tuned, adds more low-end
/ midrange and if the proper main jet is selected, more top-end power. Easy to install and tune - no slide drilling!

not available
CRB-S19-3.0
Config 30 carb kit
Not available. No room for filters.

NA 

Factory Pro Ignition Advancer / Ignition Advance Rotor

RTR-SUZ-61-04
 
$89.95

International buyers will be billed additional $18 for shipping

Ignition Advance Rotor

This simple, bolt-on advance kit advances the timing. With stock engines with stock compression ratios, there is more power everywhere. Part throttle power is better - helping corner exit speeds. Improved in-town driveability and quicker warmup.

Factory Pro Carb Repair parts / Emulsion tubes, needle jets

RF600
Nickel plated EMULSION TUBES IN STOCK
$120/4 pcs

International buyers will be billed additional $18 for shipping

Brand NEW Factory Pro designed PLATED emulsion tubes in stock, now! Call 800 869-0497 to order!
$120 for set of 4

 
Factory Pro Shift Improvement Kit

SHFT-SUZ-4   $44.95


International buyers will be billed additional $24 for shipping

Trans Detent Spring Kit
Make shifting MUCH quicker and virtually eliminate missed shifts.

 

TL-float height gauge
 $59.95

International buyers will be billed additional $18 for shipping

The only way to accurately measure float heights. Works on nearly every carburetor.
 

True Rear Wheel Horsepower® Factory EC997a Eddy Current Dynamometer

 

Absolutely NO carb parts sold in California.

New and improved Suzuki Teka SFI  2

with new TPS display and "MMT" Memory Module Tuner

Finally - Quick, easy, cost effective Suzuki tuning with no expensive "add-on boxes"
Suzuki cruisers and sportbikes

Please click here for more info

Contact Factory Pro
M-F, 9am - 5pm, Pacific time, -7 or -8 GMT

800 869-0497
 USA and Canada

415 491-5920

parts information
 info@factorypro.com

EC997 dynamometer information
info@factorypro.com

Product Support /Tech SECTION
click here

 

Mailing / Shipping address:

Factory Pro
179 Paul Drive
San Rafael, CA 94903
USA

And most importantly
Restart back at the HOME page and click on the red box in the top left to find the bike that you want parts for...
restart at HOME page

 

This Tuning Site has been visited by
  
people.
www.digits.net - the oldest counting service on the web

          

 

 

 

LINKS
EFI and Carb Tuning - Most all FI and carb tuning

by Wheelsmith Racing

Flight Training - train with AMA race winner Todd Harrington.

The Harringtons own American Flyers, one of the most established flight training facilities in the USA.

 8 locations

 800-362-0808
The Rich Oliver Mystery School will help you discover your hidden inner strength. 
It will challenge you. It will teach you a new way of thinking, and a new way of riding. You can take your riding to an exciting new level!  

We use a variety of proven drills and training techniques. 
Practicing these techniques with our Yamaha dirt track trainers will enhance your abilities both on the track or the street.  

It doesn't matter what you ride or race, the Rich Oliver Mystery School improves everyone's skill level and mindset!

WW2 vintage flying Special

Book a sightseeing flight over the Wine Country or a Kamikaze aerobatic flight or a biplane flight over famous Sonoma Raceway, the Golden Gate Bridge and the San Francisco Bay for one or two during the spring and get a free souvenir t shirt!
(NEW!  Ask about the P-40 flights!)

707 938 2444

Just tell them that you saw this on the Factory Pro website!
Marc
Northern California's most unforgettable flying experience.  No experience required.  Open weekends!

The extension of the laboratory for engines of the Swiss Federal Institute of Technology was completed in about 1935. Its architect was Rudolf Otto Salvisberg (1882-1940). He had a successful career in Berlin but returned to Switzerland after the advent of the Nazis. His architectural style was somewhat similar to that of Erich Mendelsohn. The staircase of the laboratory is in normal use but well preserved.
Edited to the tunes of Chemical Residue by Herbie Hancock.