Suzuki GSXR1000 k9 2009 - 2010 Velocity Stacks
(thanks to Glenn, Brian and Sable at Santa Rosa Powersports 707 545-1606 for the use of one of their gsxr1000's for install pictures.

Disclaimer
This is a rough idea of the install concept - they are by no means totally inclusive of every item that should be checked. If you don't have a Genuine Suzuki Shop Manual for all the proper warnings, don't attempt this, if you have any doubts, don't do this. If this violates any emissions laws in your state, step away from the bike.

You MUST have a Genuine Suzuki Service Manual for this bike.

Tools and supplies:
Thread locking compound (mild)
Normal metric hand tools
a 7" to 9" #2 Phillips screwdriver
Allen wrenches, 4mm and 5mm, 3/8" drive
Torque wrench
Genuine Suzuki Service Manual

  1. Remove right and left side "tank/seat" frame panels -  single 4mm allen is on tank - They are also attached with "Velcro". and 2 rubber grommet / post mounts.

  2. Remove 2 seat mount screws and lift off seat.

  3. Remove passenger seat.

  4. Locate and remove the silver metal "tank hold up rod".

  5. Remove the 2 front hold down allen screws at the front of the tank.

  6. Lift up the front of the tank and use the "tank hold up rod" to hold the tank up.


we took the tank completely off for pictures.

Remove all of the airbox screws (including the one in the middle!)

To get under the tank, if there is a "normal" and a "long" screwdriver #2 Phillips length, this will take a "medium". About 8 inches or a 1/4" drive #2 Phillips driver. 3/8" allen socket is too big of a diameter for the airbox hole.

Unscrew the 6 stock velocity stack mounting screws. Lift out the stock velocity stacks.

 

Do NOT DROP ANYTHING DOWN THE THROTTLE BODY BORES.

  1. Test fit the stacks (without the bracket).

  1. Kits use stock mounting screws

    1. If supplied. install supplied anti-rattle cushioning orings on the base of the stacks.

    2. Push out stock stack mount screws and apply that drop of mild thread locking compound.

    3. Assemble "stack and bracket assembly and screws" and install in airbox.

 

 

 


Push out stock stack mount screws

  1. Finger tighten evenly.

  2. Then torque to 6 ft lbs.

 

All Kits

Double check that all 6 stack bracket bolts are tight. 6 ft lbs.


This pic is full sized to see the #4 stack "flat". RH mouse menu - click on View Image.

DOUBLE CHECK THAT YOU DID NOT DROP ANYTHING INTO THE THROTTLE BODY BORES.

If you put a rag or ?? to cover the bore of the throttle bodies - MAKE SURE YOU TAKE IT BACK OUT or the throttle WILL stick wide open.

 
Reinstall the airbox top - Don't forget the center screw.


Brian at Santa Rosa Powersports

Reinstall 2 tank mount screws, "tank hold up rod", 2 seat mount bolts, both plastic frame panels and their 2 screws and the passenger seat..